How to extend the life of a washing machine: care rules
To keep your washing machine working at its best, you need to regularly clean it from dirt, dust, and aggressive detergents. You can clean it using simple household products, Ukr.Media reports.
A mixture of baking soda and vinegar will help get rid of soap and lime stains and streaks. In addition, it prevents the development of mold and the reproduction of harmful bacteria.
Clean the inside of the washing machine
First, prepare a special washing solution. Mix water and baking soda to form a paste. Then pour the vinegar into the washing machine drum and set it to wash at a high temperature. After the cycle is finished, wipe the inside of the drum with a clean cloth.
Clean the door and drum rubber
A clean door and rubber band are the key to the quality of your washing machine. You should wipe thoroughly even in the most difficult to reach places, the rubber band can be pulled out. If you notice mold growth on the rubber band, wipe the damaged areas with vinegar or bleach. Finally, rinse the part with clean water.
To prevent mold from appearing at all, simply leave the machine door open after washing. This will prevent condensation from forming and allow the elastic to air out well.
Rinse the washing machine tray
Mold and dirt can build up in the detergent drawer. The problem is that the machine may not use all the powder, which in turn gets wet and hardens.
To clean the tray, remove it from the machine and soak it in hot water with baking soda. Then use an old toothbrush to clean the tight spots. Be sure to wipe the tray on all sides.
Clear the filter
This part protects the equipment from clogging, which extends the life of the washing machine. The filter is usually located in the lower right part. It needs to be washed once every six months. If this is not done, the machine will not drain water well and wash clothes.
First, unscrew the filter from the machine. Remember to place a cloth under the machine, as some water may spill out of the washing machine when you remove the part. Wipe the filter well, removing any dirt, dust or hair. Then put the part back in.
Джерело: Source